3m Dinoc Please Advice
-
blessthedead
- Posts: 2
- Joined: Mon Oct 26, 2009 1:19 am
3m Dinoc Please Advice
I just was wondering about how to install 3m Dinoc carbon onto my accord. i want to wrap my bonnet and roof but since the Length is 10m and the height is only 1.22, the size doesn't fit. What am i suppose to do, am i suppose to use 2 pieces of 3m and join them together for my bonnet? If it's a yes, wont it look ugly because from my perspective it would have a line going through the middle of my bonnet.
if the area bigger than the film, then only to tackle them
join them a proper location (example on the bonnet line) else on the least obvious location as the film will curl nicely with heat gun
you'll be amazed how the film works around complex curves but there would be a decent amount of seams which can be cleared with proper amout of heat and it look almost invisible with proper aligment.
PS - remember to heat the seam properly else the natural heat will "help" you later and you'll get a "river" on your bonnet
join them a proper location (example on the bonnet line) else on the least obvious location as the film will curl nicely with heat gun
you'll be amazed how the film works around complex curves but there would be a decent amount of seams which can be cleared with proper amout of heat and it look almost invisible with proper aligment.
PS - remember to heat the seam properly else the natural heat will "help" you later and you'll get a "river" on your bonnet