Page 1 of 1
shuddering when turning steering left while sationary
Posted: Sun Jul 21, 2013 5:18 pm
by tlkchew
Hi All,
have anyone experienced shuddering when turning the steering wheel while stationary. turning right does not have this issue.
moving also does not have this.
its almost like the steering motor on the left does not have enough power.
This is on a CU2.
Thanks and look forward to any input.
Posted: Sun Aug 11, 2013 3:04 pm
by fiqueudrue
same issue im facing. turning left, esp reverse, sound quite loud, darm paiseh
was diagnose with steering rack, plus steering module problem. (btw mine was electric steering)
repair wise, not gonna do it, so let it be.
Posted: Wed Aug 14, 2013 10:54 pm
by tlkchew
fiqueudrue wrote:same issue im facing. turning left, esp reverse, sound quite loud, darm paiseh
was diagnose with steering rack, plus steering module problem. (btw mine was electric steering)
repair wise, not gonna do it, so let it be.
yes mine is the same left turn only... right is perfectly fine, it is electric steering. steering module sounds expensive... any idea where to get it fixed?
seems to be pretty loud now...
anyone suggest a workshop for this?
Thanks
ken
Posted: Wed Aug 21, 2013 5:09 pm
by tlkchew
this forum is as slow as my car
guess will live with it...
Posted: Mon Aug 26, 2013 8:37 pm
by fiqueudrue
tlkchew wrote:this forum is as slow as my car
guess will live with it...
hahaha sorry sorry.
not active la.
for me go back agent free diagnose.
outside not sure lei
Solved!
Posted: Mon Nov 11, 2013 11:50 am
by tlkchew
My Mechanic did some check on the computer and did some reset to the steering...
Did some full locks to the left and right and then center with the computer plugged in and the problem went away... so much for agents diagnostics of having to change the module and actuator...
Go try it at any workshop with the diagnostic computer that is able to pick up and scan our CU2 codes should be able to work.
Re: Solved!
Posted: Fri Nov 15, 2013 3:40 pm
by fiqueudrue
tlkchew wrote:My Mechanic did some check on the computer and did some reset to the steering...
Did some full locks to the left and right and then center with the computer plugged in and the problem went away... so much for agents diagnostics of having to change the module and actuator...
Go try it at any workshop with the diagnostic computer that is able to pick up and scan our CU2 codes should be able to work.
bro whats your workshop?
share with me i want to go.
Thanks