Slotted Rotor
Posted: Mon Jun 07, 2010 9:08 pm
Hi guy can any one tell me where can i get my stock rotor slotted n drill??
Wat is the cost mostly lik??
Wat is the cost mostly lik??
Page 1 of 1
Posted: Tue Jun 08, 2010 6:49 pm
r u nuts drill ur stock rotor?? go get a proper 1 out there.. is cheaper n safer that way.
Posted: Wed Jun 23, 2010 9:38 pm
Go hardware shop get a drill.
use penknife cut slots
use penknife cut slots
Posted: Wed Jun 23, 2010 10:52 pm
Gresini wrote:Go hardware shop get a drill.
use penknife cut slots
Posted: Thu Jun 24, 2010 3:00 am
slot is gd enough.
if you hv a regular ws , they will know who to push to...but the cost is high. do in jb much cheaper
if you hv a regular ws , they will know who to push to...but the cost is high. do in jb much cheaper
Posted: Thu Jun 24, 2010 9:38 am
Please note all factory slots/holes are done before treatment. Any skimming, drilling, slotting after production withour further treatment reduces efficiency and may cause severe damage due to uneven heat distribution during operation.