R3Dvtec wrote:Currently parking in the workshop...
Re-modding the new engine block with new pistons..
and some extras mods...
engine ready for "plug & play"..
any comments welcome.. here we go...
Engine
Engine Head p08-04 port & polish (D16z6)
D16Y8 Block oversize 100 (new block)
PM3 Piston oversize 76mm
Modded throttle body port match IM
Skunk2 Pro Intake manifold
SARD FPR
HighFlow Walbro Fuel pump
MSD 6AL with Rev Control + MSD Blaster SS Coil
Denso Iridium spark plugs
High Flow air intake
4-2-1 exhaust header with heat wrap.
Areospeed Carbon fibre titanium exhaust
greddy oli catch tank
Koyorad Racing Radiator with autobann hose
buddyclub high pressure radiator cap
J's Racing low temp fan switch
Spoon low temp Themostat
pivot mega raizin
ECU Remap - rev limit at 8000rpm & open speed limiter
Dastek Unchip Q with vtec module
Struts & transmission
Skunk2 Front & back strutbar.
Exedy stage 2 racing clutch
Endless braided brake hose
ATE Power Disc with Bendix Ultimate pads
bilstein tuning kit coilovers
RacingHart 5 17" rims
interior
Apexi RSM meter
Apexi Turbo Timer with o2/air fuel meter
Momo Nero steer + Nero shift
Momo Pit Stop carbon fibre handbrake
Momo Atomik pedals + carpet pad
Momo Carpet w/step board
JAW shift lamp
Custom Vtec-on led (self mod, hehe)
Timex water temp + vacuum pressure gauge
audio
head unit JVC - KD AVX 44
Vifa logic reference 6.1 speaker & tweeter
Kicker 3 way system for rear
DLS DLS RA-40 Power
Crossfire BMF 600.1 Monoblock
Crossfire CQ30.2 30-Band Car Equalizer
Kicker CVR 10" sub x 2
Intersys Bank Cap 2 Farad
Full Blackjack audio cable
my Egoist Red Devil..
will update the pictures once engine is done...
enjoy...