Slotted Rotor

steven_koh · Post by **steven_koh** » Mon Jun 07, 2010 9:08 pm

Hi guy can any one tell me where can i get my stock rotor slotted n drill??

Wat is the cost mostly lik??

calvin1 · Post by **calvin1** » Tue Jun 08, 2010 6:49 pm

r u nuts drill ur stock rotor?? go get a proper 1 out there.. is cheaper n safer that way.

Gresini · Post by **Gresini** » Wed Jun 23, 2010 9:38 pm

Go hardware shop get a drill.
use penknife cut slots

wpyeo · Post by **wpyeo** » Wed Jun 23, 2010 10:52 pm

Gresini wrote:Go hardware shop get a drill.
use penknife cut slots

bugis_kid · Post by **bugis_kid** » Thu Jun 24, 2010 3:00 am

slot is gd enough.

if you hv a regular ws , they will know who to push to...but the cost is high. do in jb much cheaper

Gresini · Post by **Gresini** » Thu Jun 24, 2010 9:38 am

Please note all factory slots/holes are done before treatment. Any skimming, drilling, slotting after production withour further treatment reduces efficiency and may cause severe damage due to uneven heat distribution during operation.