Hi All,
have anyone experienced shuddering when turning the steering wheel while stationary. turning right does not have this issue.
moving also does not have this.
its almost like the steering motor on the left does not have enough power.
This is on a CU2.
Thanks and look forward to any input.
shuddering when turning steering left while sationary
- fiqueudrue
- 8000rpm Red Line
- Posts: 1632
- Joined: Mon Dec 10, 2007 9:56 am
- Location: Tampines St 91
- Contact:
yes mine is the same left turn only... right is perfectly fine, it is electric steering. steering module sounds expensive... any idea where to get it fixed?fiqueudrue wrote:same issue im facing. turning left, esp reverse, sound quite loud, darm paiseh
was diagnose with steering rack, plus steering module problem. (btw mine was electric steering)
repair wise, not gonna do it, so let it be.
seems to be pretty loud now...
anyone suggest a workshop for this?
Thanks
ken
- fiqueudrue
- 8000rpm Red Line
- Posts: 1632
- Joined: Mon Dec 10, 2007 9:56 am
- Location: Tampines St 91
- Contact:
Solved!
My Mechanic did some check on the computer and did some reset to the steering...
Did some full locks to the left and right and then center with the computer plugged in and the problem went away... so much for agents diagnostics of having to change the module and actuator...
Go try it at any workshop with the diagnostic computer that is able to pick up and scan our CU2 codes should be able to work.
Did some full locks to the left and right and then center with the computer plugged in and the problem went away... so much for agents diagnostics of having to change the module and actuator...
Go try it at any workshop with the diagnostic computer that is able to pick up and scan our CU2 codes should be able to work.
- fiqueudrue
- 8000rpm Red Line
- Posts: 1632
- Joined: Mon Dec 10, 2007 9:56 am
- Location: Tampines St 91
- Contact:
Re: Solved!
bro whats your workshop?tlkchew wrote:My Mechanic did some check on the computer and did some reset to the steering...
Did some full locks to the left and right and then center with the computer plugged in and the problem went away... so much for agents diagnostics of having to change the module and actuator...
Go try it at any workshop with the diagnostic computer that is able to pick up and scan our CU2 codes should be able to work.
share with me i want to go.
Thanks